Left Seal, Replacing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Remove the transmission. Refer to the appropriate Service Information. .

-- Remove the left and right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Remove the left flange shaft slightly from the transmission but do not remove completely. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and the final drive cover.

Fig 1: Identifying Bolts -Arrows-

Courtesy of AUDI

CAUTION:

Danger of causing damage to the differential.

Slowly and carefully remove final drive cover from transmission housing. Otherwise differential can fall out of transmission.
A differential that has fallen out can no longer be installed. If the differential falls out, the transmission must be replaced.

-- Carefully remove the front final drive cover. At the same time some transmission fluid will drain out.

-- Carefully remove the differential -1- and lay it on a soft support.

Courtesy of AUDI

-- Position the inner section of the Puller - Camshaft Seal:3240 flush with the outer section and lock the inner section using the knurled bolt.

Courtesy of AUDI

-- Lubricate the puller threads, position, and using strong pressure insert the puller - camshaft seal as far as possible in the seal until the seal turns.

-- Turn the puller - camshaft seal further and at the same time pull until the seal is removed.

-- Tension the puller - camshaft seal on the flat side in a vise and remove the seal using pliers.

-- Check the seal in the transmission housing for damage and rework if necessary.

-- Clean the running and sealing surface.