Adjustment Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- When performing assembly work on the transmission a new adjustment of the pinion ring gear (differential) is only required if components were replaced which directly influence the final drive adjustment.
- No adjustment is needed when replacing drive pinion double angular contact ball bearing.
- Note the following table to avoid unnecessary adjustments:
| To be adjusted: | Pinion | Ring gear | Torsional backlash | ||
| ("S 3 " + "S 4 ") | ("S 1 " + "S 2 ") | 0.15 ± 0.04 mm | |||
| Refer to PINION, ADJUSTING | Refer to FINAL DRIVE, ADJUSTING | Refer to Torsional Backlash, Measuring or Torsional Backlash, Measuring . | |||
| Replaced part | |||||
| Transmission Housing | X | X | X | ||
| Differential (1) | X | X | |||
| Differential bearing | X | X | |||
| Pinion (1) | X | X | X | ||
| Final Drive Cover | X | X | |||
|
|||||
Sequence for readjusting final drive set
If the pinion and ring gear (differential) must be adjusted, maintain the following sequence, in the interests of a rational sequence:
- Total shim thickness "S total " Determine (S1 plus S2 ) for specified preload of tapered roller bearing/differential.
- Determine the shim "S3 " so that the dimension from center of ring gear to facing drive of drive pinion corresponds to the installation dimension determined during production.
- Shim "S 4 " for positioning the double angular contact ball bearing/pinion in the transmission housing.
- Total shim thickness "S total " Distribute (S1 plus S2 ) so that the specified torsional backlash is present between the ring gear and the drive pinion.