Right Flange Shaft, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the circlip after removal.
-- Insert the circlip -1- with the Circlip Pliers:VAS 5503A .
-- Check the right flange shaft seal for damage and replace if necessary.
-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease.
-- Insert the right flange shaft.
-- Fill the transmission fluid and check the level. Refer to TRANSMISSION FLUID .
Tightening Specifications
- Refer to OVERVIEW - DRIVE AXLE .
- Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .