Mounting Bracket And Ball Bearing For Left Flange Shaft, Replacing

Special tools and workshop equipment required 

• Press Plate:VW 401 
  Fig 1: Press Plate

  Courtesy of AUDI
• Press Plate:VW 402 
  Fig 2: Press Plate VW402

  Courtesy of AUDI
• Press Piece - Multiple Use:VW 412 
  Fig 3: Identifying Press Piece - Multiple Use VW412

  Courtesy of AUDI
• Press Piece - 42mm:VW 516 
  Fig 4: Press Piece - 42 mm VW516

  Courtesy of AUDI

-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

Fig 5: Identifying Circlip -1- In Flange Shaft Groove

Courtesy of AUDI

-- Remove the circlip -1- from the flange shaft.

-- Remove the ball bearing -A- from the flange shaft

Fig 6: Ball Bearing

Courtesy of AUDI

-- Install the new mounting bracket -1-.

Fig 7: Ball Bearing & Bracket

Courtesy of AUDI

• Installed position: the printed side faces the drive axle flange

-- Install the new ball bearing -2-.

-- Install the ball bearing -A- all the way on with the mounting bracket -B- installed.

Fig 8: Identifying Ball Bearing, Installation

Courtesy of AUDI

-- Install the new circlip -1- in the flange shaft groove.

Fig 9: Identifying Circlip -1- In Flange Shaft Groove

Courtesy of AUDI