Overview - Transmission Housing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Transmission Cover

Courtesy of AUDI

Circlip
Pinion Roller Sleeve
- Bearing "I"
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Transmission Housing
Seal
- For the transmission output shaft.
- Only on vehicles with an all-wheel drive clutch
- Replacing. Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING .
Cap
- Replace after removing
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Fluid Catch Tray
- Replace after removing
Input Shaft Ball Bearing
- Bearing "E"
- Installation position: the surrounding groove points to the transmission housing.
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Circlip
- Installation position. Refer to Figure
Roller Sleeve for the Output Shaft
- Bearing "F"
  FWD Vehicles
- Replace after removing
- Removing. Refer to Figure.
- Installing. Refer to Figure.
  AWD Vehicles
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Circlip
- Different versions
- Refer to the appropriate Electronic Parts Information for the allocation.