EVAP Canister, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the right rear wheel housing liner. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .

Versions without Tank Leak Diagnosis:

Courtesy of AUDI

-- Remove the bolts/nut -arrows- and remove the EVAP canister -2- with the bracket.

-- Disconnect the vent and bleeder lines -1-. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, DISCONNECTING .

Versions with Fuel Tank Pressure Sensor -G400- /Fuel Tank Leak Detection Module -GX36-

Courtesy of AUDI

-- If installed, disconnect the connector for the Tank Switch-Off Valve -N288-.

-- Remove the bolts/nut -arrows- and remove the EVAP canister -1- with the bracket.

-- Disconnect the vent and bleeder lines -2-. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, DISCONNECTING .

-- Version with Tank Switch-Off Valve -N288- : remove the EVAP canister with the bracket by twisting and turning.