Flywheel, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Carefully Set Down Electro-Drive Drive Motor

Courtesy of AUDI

Install in the reverse order of removal while noting the following:

-- Always clean the transmission housing in the area where the differential -arrow A- and the shaft seal -arrow B- are accessed.

Replace damaged shaft seals located between the differential and the transmission housing -arrow B-.

-- Fill the space between the sealing/dust lip halfway with sealing grease. Refer to the appropriate Electronic Parts Information for the correct sealing grease.

-- Clean the input shaft -arrow-.

Fig 2: Identifying Input Shaft

Courtesy of AUDI

-- Lightly grease the input shaft splines with Grease for Clutch Plate Shaft Splines.

-- Slide the clutch module onto the input shaft -arrow- carefully without tilting it.

Fig 3: Identifying Flywheel Components, Remove/Install

Courtesy of AUDI

-- Remove the Puller - Clutch Module:T40176 from the flywheel -A-.

Fig 4: Attaching Puller - Clutch Module T40176 To Clutch Module -A-

Courtesy of AUDI

-- Install the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .