Cam Adjustment Actuator, Removing And Installing: Notes
WARNING: This page is about a different car, the 2024 Audi Q5 and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Removing
All except Audi Q7/Q8:
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
Audi Q7/Q8:
-- Remove the cap -2-.
-- Release the retainer -arrow B- and remove the oil filler tube -1- upward from the air filter lower section.
-- Turn the oil filler tube counter-clockwise -arrow A- and remove it.
-- Close the oil filler tube with the cap.
Continuation for All Vehicles:
-- Cam Adjustment Actuator 1 -F366- : free up the wires and slightly push to the side.
-- Disconnect the connector -2-.
-- Remove the bolt -1- and the cam adjustment actuator.