Vibration Damper Seal, Replacing: Removing

WARNING: This page is about a different car, the 2024 Audi Q5 and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seal Installer - Crankshaft T40274

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Remove the seal -arrow- with the Seal Installer - Crankshaft:T40274 .

-- Clean the contact and sealing surface.

-- Push the seal -arrow- on the Seal Installer - Crankshaft:T10354 .

Fig 2: Identifying Crankshaft Seal Installer T10354

Courtesy of AUDI OF AMERICA, LLC

The closed side of the seal points to the Seal Installer - Crankshaft:T10354 .

-- Push the seal -arrow- with the Seal Installer - Crankshaft:T10354 on the Vibration Damper Assembly Tool - Tensioning Pins:T10531/6 -item 1- and place on the lower timing chain cover.

Courtesy of AUDI OF AMERICA, LLC

-- Also screw in the Press Piece - Gearbox:T10375 and tighten the Vibration Damper Assembly Tool - Knurled Nut:T10531/4 .

Fig 3: Driving Seal In Using Seal Installer - Crankshaft T10354

Courtesy of AUDI OF AMERICA, LLC

-- Drive the seal in all the way using the Seal Installer - Crankshaft:T10354 .