Oil Spray Jets, Removing And Installing

Special tools and workshop equipment required 

• Socket: T10545 
  Fig 1: Torx Bit - T40

  Courtesy of AUDI OF AMERICA, LLC
• Wrench - 21mm:T40263 
  Fig 2: Identifying Wrench - 21mm

  Courtesy of AUDI OF AMERICA, LLC
• Adapter:T40314 
  Fig 3: Adapter T40314

  Courtesy of AUDI OF AMERICA, LLC

Removing cylinder "1" through "3" :

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

Fig 4: Using T40263 & T40314

Courtesy of AUDI OF AMERICA, LLC

-- Turn the crankshaft at the vibration damper with the Wrench - 21mm: T40263  , Adapter:T40314  and the 24 mm socket -arrow- until the corresponding bolt is accessible.

Removing cylinder "4" :

-- Remove the crankshaft. Refer to CRANKSHAFT, REMOVING AND INSTALLING .

Continued for all cylinders:

Fig 5: Exploded View Of Oil Spray Jet And Pressure Relief Valve

Courtesy of AUDI OF AMERICA, LLC

-- Remove the pressure relief valve -1- using the Torx Bit - T40:T10545  .

-- Remove the oil spray jet -2-.

Installing

Install in the reverse order of removal while noting the following:

• Installation position. Refer to Figure.

-- Install the crankshaft. Refer to CRANKSHAFT, REMOVING AND INSTALLING .

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

Tightening Specifications

• Refer to OVERVIEW - PISTONS AND CONNECTING ROD 
• Refer to OVERVIEW - CRANKSHAFT