Sub-Assembly Bracket, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

• Replace bolts that were tightened with an additional turn after removing them.
• Replace the O-ring and seals after removing.
• Used coolant cannot be used again.

-- Coat the new O-rings -4- with coolant.

Courtesy of AUDI OF AMERICA, LLC

-- Insert the connecting piece -2- in the Engine Temperature Control Adjusting Element -N493- -item 3-.

-- Push the engine oil cooler -1- with the sub-assembly bracket onto the connecting piece, position the bolts and tighten.

-- Install the generator/starter generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Install the A/C compressor. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING or A/C COMPRESSOR, REMOVING AND INSTALLING .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install the oil filter element and check the oil level. Refer to ENGINE OIL .

-- Connect the coolant hose to the connector coupling. Refer to Fig 1.

Fig 1: Connect the Coolant Hose to the Connector Coupling

Courtesy of AUDI OF AMERICA, LLC

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Fill the cooling system. Refer to COOLANT, FILLING USING Cooling System Charge Kit:VAS 6096 [DMTA, DPAA, DPUA, DPVA, DMTC, DRYA, DUVA] .