Ribbed Belt, Removing And Installing, Vehicle With Starter Generator: Installing

WARNING: This page is about a different car, the 2024 Audi Q5 and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Install the ribbed belt. Refer to Figure.

If the ribbed belt tensioner is not locked the assembly condition must be created first. Refer to If there is no ribbed belt installed (torn, for example): .

-- Turn the tensioning system slightly in the -direction of the arrow- and remove the Locking Pin:T10060 A .

-- Release the tension on the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Start the engine and check whether the ribbed belt runs correctly.