Rear Sensor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Press both tabs in the direction of -arrows- to the side and press the sensor -1- inward from the outside.
-- Disconnect the connector -2- by sliding the retainer -3- toward the rear and pressing the release down.