Front Sensor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the wheel housing liner in the front area and push it aside. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Versions with auxiliary radiator: remove the front wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- Press both retainers to the side in the direction of -arrows- and at the same time, push the sensor -1- through from the outside toward the inside.
-- Disconnect the connector -2- by sliding the retainer -3- toward the rear and pressing the release down.