Alcohol Interlock System, Removal
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Pay attention to the manufacturer instructions.
Removing
-- Connect the Vehicle Diagnostic Tester.
-- Select "flash".
-- Select "Enter SVM code".
-- Perform the software update with SVM code -46A610-.
-- Switch off the ignition.
-- Remove the 20 A fuse in Fuse Panel 3 - ST3- from location 6 in the left side of the luggage compartment.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Remove the alcohol interlock system control module and handheld from the glove compartment.
-- Remove the wires from the glove compartment, secure them to the bulkhead and insulate them.
-- Remove the grommet, close holes in the glove compartment with fitting plugs.
-- Install the glove compartment.