LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wheels, Tires, Wheel Alignment (Wheel And Tire Guide General Information)) >> 44 Wheels, Tires, Wheel Alignment >> Tires, Mounting >> Tire And Wheel Radial And Lateral Run-Out, Checking >> Tire And Wheel Radial And Lateral Run-Out, Checking, Tolerances >> Notes

Tire And Wheel Radial And Lateral Run-Out, Checking, Tolerances: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Radial and lateral run-out occur when the wheel and tire are not running precisely true.

For technical reasons, 100% true running is not possible.

Therefore the manufacturers of these components allow a precisely specified tolerance.

Mounting the tire in a unfavorable position on the wheel can be the cause for exceeding the maximum allowed tolerance for wheel with tire.

The table shows the maximum permissible tolerance values for the wheel with mounted tire.

scientia non olet · About LEMON Manuals