LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wheels, Tires, Wheel Alignment (Wheel And Tire Guide General Information)) >> 44 Wheels, Tires, Wheel Alignment >> Tire Pressure Monitoring System >> Metal Valve, Removing And Installing >> Metal Valve, Removing And Installing, Version 1 >> Installing

Metal Valve, Removing And Installing, Version 1: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Clean the valve hole.

-- Insert the metal valve into the valve hole, attach the washer and tighten the union nut to tightening specification.

-- Secure the valve using the 2 mm pin against turning.

Fig 1: Securing Against Turning With Counter Hold
GWWA44-0085Courtesy of AUDI

-- Install the tire pressure monitoring sensor.

scientia non olet · About LEMON Manuals