LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wheels, Tires, Wheel Alignment (Wheel And Tire Guide General Information)) >> 44 Wheels, Tires, Wheel Alignment >> Rim Information >> Valve, Removing And Installing >> Valve, Removing And Installing, Metal Valve >> Installing

Valve, Removing And Installing, Metal Valve: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Only apply the specified torque to tighten the nut for the metal valve.

Tightening more is not permitted because it damages the seal.

-- Tighten the nut -1- of the metal valve.

Fig 1: Identifying Metal Valve
GWWN44-10443Courtesy of AUDI

-- Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.

-- Install the Tire Pressure Monitoring Sensor --.

-- Fill the tire to the specified pressure.

CAUTION:

Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseparable connection and cannot be separated again.

scientia non olet · About LEMON Manuals