LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wheels, Tires, Wheel Alignment (Wheel And Tire Guide General Information)) >> 44 Wheels, Tires, Wheel Alignment >> Component Overview >> Component Overview - Alloy Wheel

Component Overview - Alloy Wheel

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Alloy Wheels
GWWA44-10056Courtesy of AUDI
  1. Tires
    CAUTION:

    The minimum mounting temperature for a tire may not be below 21 °C (69.8 °F) or above 30 °C (86 °F).

  2. Valve
    • Always replace.
    • Refer to the appropriate Electronic Parts Information for the allocation of the only valves to be installed.
      CAUTION:

      Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseparable connection and cannot be separated again.

  3. Wheel
    • Note the assembly instructions.
  4. Wheel Bolt
    • Anti-theft wheel bolts.
  5. Wheel Bolt Adapter
    • Attach to the wheel bolt intended for it.
  6. Cap for Wheel Bolts
    NOTE:

    After achieving and checking the correct torque on "all-wheel bolts", install the caps completely on the wheel bolts.

    Use the back of a screwdriver or a suitable tool to do this. Do not damage the cap.

  7. Cap
  8. Wheel Bolt
    NOTE:

    Make sure the correct wheel bolts are installed. Refer to the appropriate Electronic Parts Information.

  9. Adhesive Balancing Weights
    • Maximum 60 grams per rim flange permitted
    • Clean wheel where it will be adhered so it is free of dirt and grease
    • Remove protective film.
    • Attach balance weights to intended surfaces.
scientia non olet · About LEMON Manuals