Overview - Ignition System
WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 22 Nm
- Knock Sensor 1 -G61-
- Removing and Installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Spark Plug
- 27.5 Nm
- Spark Plug Connectors
- Ignition Coil
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Removing and Installing. Refer to IGNITION COILS, REMOVING AND INSTALLING .
- Double Bolt
- In the existing threads: 9 Nm
- In the new tapping threads: 10 Nm
- Thread cutting
- Nut
- 9 Nm
- Bolt
- In the existing threads: 9 Nm
- In the new tapping threads: 9 Nm
- Thread cutting
- Camshaft Position Sensor 3 -G300-
- Removing and Installing. Refer to Camshaft Position Sensor 3 -G300-, REMOVING AND INSTALLING .
- Check the O-ring for damage
- O-Ring
- Not available separately; replace if leaking -item 9- OVERVIEW - IGNITION SYSTEM or damaged
- O-Ring
- Not available separately; replace if leaking -item 12- OVERVIEW - IGNITION SYSTEM or damaged
- Camshaft Position Sensor -G40-
- Removing and Installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
- Check the O-ring for damage
- Bolt
- 9 Nm
- O-Ring
- Not available separately; replace if leaking -item 15- OVERVIEW - IGNITION SYSTEM or damaged
- Engine Speed Sensor -G28-
- Removing and Installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Check the O-ring for damage
- Bolt
- 4 Nm +45°
- Replace after removing