Overview - Coolant Pump/Coolant Thermostat: Notes
WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
(Shown On 3.0L Engine).
- Coolant Shut-Off Valve
- Removing and installing. Refer to COOLANT VALVES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Map Controlled Engine Cooling Thermostat -F265-
- Removing and installing. Refer to Map Controlled Engine Cooling Thermostat -F265- , REMOVING AND INSTALLING .
- Bolt
- 10 Nm + 90°
- Always replace after removing.
- Belt Pulley
- For the coolant pump
- Coolant Pump
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
- Bolt
- Tightening Specifications and Sequence. Refer to Figure.
- Seal
- Always replace after removing.
- Seal
- Replace the Map Controlled Engine Cooling Thermostat -F265- after removing
- O-Ring
- Always replace after removing.
- O-Ring
- Always replace after removing.
- Seal
- Always replace after removing.
- Bolt
- 9 Nm