Map Controlled Engine Cooling Thermostat -F265- , REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work may be required depending on the model. Refer to MAP CONTROLLED ENGINE COOLING THERMOSTAT -F265-, REMOVING AND INSTALLING - 3.0L .
-- Remove the connector -1- from the bracket.
-- Remove the Cylinder Block Coolant Valve -N545- -4- from the bracket and push it to the side.
-- Disconnect the connector -2- and free up the wires on the Map Controlled Engine Cooling Thermostat -F265- .
-- Remove the bolts -arrows- and remove the Map Controlled Engine Cooling Thermostat -F265- .
-- Dismount the seal -arrow- with the extractor lever -2- .