BATTERY TEST WITH Vehicle Diagnostic Tester
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
NOTE:
The Battery -A- can also be checked while it is installed without the connected battery charger on vehicles with Battery Monitoring Control Module -J367- or Energy Management Control Module -J644- and Data Bus on Board Diagnostic Interface -J533- using the Vehicle Diagnostic Tester.
Test Prerequisites
- No battery charger connected
- Battery -A- is connected.
- Battery temperature at least +10 °C (50 °F).
Procedure
Vehicle Diagnostic Tester is attached.
-- Select the Diagnostic mode and start the diagnostics.
-- Select the tab Test Plan .
-- Select Select Individual Tests and choose the following sequence.
- Body
- Electrical Equipment
- 27 - Starter, voltage supply
- Electrical Components
- A - Battery, Checking
The Vehicle Diagnostic Tester continues with the battery test from here on.