GROUND CABLE WITH Battery Monitoring Control Module -J367-, REMOVING AND INSTALLING: Removing

-- Switch off the ignition.

-- Adjust the right front seat as far to the rear as possible. Use the entire adjustment range of the seat adjustment for this.

-- Remove the floor mat from the footwell.

-- Release the cover -1- upward in direction of -arrow A- and remove toward the center of the vehicle in direction of -arrow B-.

Courtesy of AUDI OF AMERICA, LLC

-- Open the cover -6- over the battery negative terminal.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nut -1- several turns and remove the battery ground cable clamp from the battery terminal.

-- Disconnect the connector -3-.

-- Slightly lift the carpet in the area of the nut -5-.

-- Remove the nut -5- and ground cable -4- with the Battery Monitoring Control Module -J367- -2-.