Battery -A-, REMOVING AND INSTALLING: Removing
-- On vehicles with 48 Volt system, de-energize the 48 Volt system. Refer to 48V SYSTEM, DE-ENERGIZING .
-- Switch off the ignition.
-- Adjust the right front seat as far to the rear as possible. Use the entire adjustment range of the seat adjustment for this.
-- Remove the floor mat from the footwell.
-- Release the cover -1- upward in direction of -arrow A- and remove toward the center of the vehicle in direction of -arrow B-.
-- Open the cover -3- over the battery negative terminal.
-- Loosen the nut -1- several turns and remove the battery ground cable clamp -2- from the battery terminal.
-- Open the cover -1- over the battery positive terminal.
-- Loosen the nut -3- several turns and remove the battery positive cable terminal clamp -2- from the battery terminal.
-- Remove the nuts -3 and 5-.
-- Disengage the retaining bracket -1- on the opposite side.
-- Remove the battery bracket -4- upward.
-- Remove the battery cover -2-.
-- Remove the central venting system hose -6-.
-- Lift the Battery -A- upward out of the front passenger footwell.
- The disposal regulations for batteries and sulfuric acid must be followed when disposing of batteries. Refer to Battery .