Right Flange Shaft, Removing And Installing: Installing

Courtesy of AUDI

Install in the reverse order of removal while noting the following:

NOTE:

Replace the circlip after removal.

-- Insert the circlip -1- with the Circlip Pliers:VAS5503A .

-- Check the right flange shaft seal for damage and replace if necessary. Refer to RIGHT SEAL, REPLACING .

-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease.

-- Insert the right flange shaft.

-- Install the drive axle. Refer to OVERVIEW - DRIVE AXLE .

-- Install the drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .

-- Gear oil level in front final drive, checking and filling. Refer to GEAR OIL .