Carbon-Ceramic Brake Wear Tester: VAS6813, CHECKING
"Before" measuring, the Carbon-Ceramic Brake Wear Tester: VAS6813 must be checked using the measurement plate provided.
Measurement Plate:
-- Place the measuring device in both openings of the measurement plate, -arrows- so that the laser beam points under the mark with the attached reference value.
-- Switch on the measuring device.
The value displayed on the display must correspond to the reference value attached to the measurement plate.
TIP:
- If the difference to the reference value is more than ± 2.0 units the measuring device must be recalibrated by a specialist company.
- For more information refer to the supplied Owner's Manual.