Vacuum Pump, Removing And Installing, Vehicle With 3.0L TFSI Engine: Installing

Install in reverse order of removal and note the following:

• Replace the seal after removal.
• Check the vacuum lines for damage before assembling and replace if necessary.
• Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.

-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning in direction of -arrows-.

Fig 1: Position Vacuum Pump Yoke

Courtesy of AUDI OF AMERICA, LLC

-- Push the new hose clamp over the vacuum hose.

-- Install the vacuum hose with the hose clamp -1- connected.

Fig 2: Locating Hose Clamp -1-

Courtesy of AUDI OF AMERICA, LLC

-- Install the lower air duct pipe. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .