Brake Fluid Reservoir, Removing And Installing: Removing
-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
Leaking brake fluid increases the risk of injury.
Risk of skin irritation and injury.
- Wear safety gloves.
-- Open the brake fluid reservoir.
Risk of accident due to the brakes malfunctioning.
- Brake fluid must never come into contact with fluids containing mineral oils (oil, gasoline, cleaning solutions).
- Do not use safety gloves that have been dirtied by oil or grease.
-- Extract as much brake fluid as possible from the brake fluid reservoir using the : VAS5234 with the : VAS5234/1 .
There is a risk of contamination and paint damage from leaking brake fluid.
- Rinse off any leaking brake fluid immediately using plenty of water.
-- Disconnect the connector -2- for the Brake Fluid Level Warning Switch -F34-.
-- To prevent brake fluid from escaping, place enough lint-free cloths in the area under the brake master cylinder.
-- Remove the locking pin -arrow- on the side of the brake fluid reservoir and from the brake master cylinder.
-- Remove the brake fluid reservoir -1- from the plugs.
-- Seal the open lines and connections immediately with plugs from the Assembly Part Set: 5Q0 698 311 .