Brake Fluid Reservoir, Removing And Installing: Installing

-- Coat the plugs in the brake master cylinder with brake fluid.

-- Insert the brake fluid reservoir into the plugs in the brake master cylinder.

-- Install the securing pin -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Check if the securing pin is sitting in the brake fluid reservoir mounting tabs and in the brake master cylinder.

-- Connect the connector -2- for the Brake Fluid Level Warning Switch -F34-.

-- Fill the brake fluid reservoir up to the "MIN" mark.

Fig 1: Brake Fluid Reservoir

Courtesy of AUDI OF AMERICA, LLC

-- Remove all cloths from the vehicle that were previously placed down.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .