Cover, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- The vehicle and the cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Remove the protective film from the adhesive tape -2, 3 and 4-.
-- Engage the door cover -1- on the bottom of the door -6- and align via the locating pin -5-.
-- Press the door cover clips -1- on until they click into place -arrows-.
-- Press on the door cover in the area of the adhesive surface with the Roller : 3356 .
- Vehicle resting time is at least 30 minutes at room temperature.