Sunroof Control Module -J245-, PROGRAMMING

If the Power Sunroof Control Module -J245- was replaced, it must be activated after installing.

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Diagnostic-Capable Systems
• 00CA - Sunroof Control Module J245
• 00CA - Sunroof Control Module J245 Functions
• 00CA - Replace the control module

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.