Glass Panel, Removing And Installing, Rear: Installing

Install in reverse order of removal and note the following:

• Remove any locking fluid residue from the threaded hole using a thread tap.

-- When inserting and sliding into the roof opening, the rain water drain channel -1- must be slid under the seal -2- using the : T10383/1 

Courtesy of AUDI OF AMERICA, LLC

-- Install the rear glass panel bolts, but do not tighten.

-- Adjust the rear glass panel (refer to GLASS PANEL, ADJUSTING ), then tighten the bolts.

-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .