Backrest Heating Element, Removing And Installing

The old heating elements remain on the cushion and will be covered over by the new heating elements.

Procedure 

• Cover and cushion separated. Refer to COVER AND CUSHION, SEPARATING, REAR SEAT BACKREST .

-- Cut the wire -3- directly at the old heating element.

-- Align the new heating element -1- on the cushion -2- .

-- Peel the protective film off the heating element. Be careful not to damage the heating element.

-- Glue the heating element so that it aligns with the old heating element and is not wrinkled.

Further Installation Is The Reverse Order Of Removal.