Backrest Cover And Cushion, Removing And Installing, Super Sport Seat: Removing

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Secure the front seat to the :VAS6136  . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the front backrest. Refer to FRONT BACKREST, REMOVING AND INSTALLING .

-- If equipped, remove the front seat backrest fan. Refer to FRONT SEAT FAN, REMOVING AND INSTALLING, SEAT BACKREST .

-- If installed, remove the massage function valve block 1 and free up the pneumatic lines for the massage mat. Refer to MASSAGE FUNCTION VALVE BLOCK, REMOVING AND INSTALLING .

-- Detach the hooks -arrows- on the backrest frame.

-- Disengage the center lower molding -1- on the backrest frame.

-- Disengage the upper and side molding from the backrest frame -arrows- .

-- Remove the front thorax airbag. Refer to FRONT THORAX AIRBAG WITH IGNITER, REMOVING AND INSTALLING .

-- Detach the inner cover molding -3- at the upholstery wire -2- by hand or using the : 3438  .

-- Free up the backrest heating wiring harness.

-- If installed, remove the massage mat pneumatic line -4- forward.

-- If installed, remove the fan rubber boot -1- from the module carrier.

-- Reach under the cushion from the rear side of the backrest and feel for the left headrest guide.

-- Press the release button -4- forward -arrow A- while pressing the release ring -3- downward -arrow B- and holding it in that position.

-- WITH HELP FROM A SECOND TECHNICIAN, REMOVE THE COVER -1- AND CUSHION WITH THE HEADREST THAT IS COVERED IN FOAM -2- UPWARD FROM THE BACKREST FRAME -ARROW C- . 

TIP:

The headrest can only be removed with difficulty.

-- Remove the cover with the cushion upward from the backrest frame.