Lumbar Support Adjustment Motors -V125- / -V126- / -V129- / -V130-, Removing And Installing: Removing
-- Remove the backrest seat cover and cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING .
-- Release and disconnect the connectors -1 and 2- at the lumbar support forward/back and height adjustment motors.
-- Cut through the cable tie and free up the wiring harness on the lumbar support.
CAUTION:
Risk of injury due to flying metal shavings.
Irritation and injury to skin and eyes possible.
- Wear protective eyewear.
- Wear safety gloves.
-- Drill out the rivet -3-.
-- Move the lower lumbar support -1- forward, pivot it out of the backrest frame, disengage it at the top of the backrest frame -2- -arrows- and remove it.