Rear Lid Upper Trim Panel, Removing And Installing
Special tools and workshop equipment required
- Pry Lever: 80-200
- Omega Clip Tool: T40280
Upper Trim Panel, Removing
-- If installed, unclip the cap -1- with a screwdriver in the direction of the -arrow A- and remove the screw behind it.
-- Unclip the upper trim panel -2- from the side trim panel in the direction of the -arrow A- using the : 80 - 200 .
-- Unclip the remaining clips and remove the trim panel -2-.
Side Trim Panel, Removing
-- Remove the rear lid lower trim panel. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .
-- Unclip the side trim panel -1- from the rear lid in the direction of the -arrow B- using the : 80 - 200 .
-- Unclip the remaining clips and remove the trim panel -1-.
Installing
Install in the reverse order of removal while noting the following:
- Before installing, check all the fasteners for damage and replace if necessary.
-- Remove any remaining clips in the body using the : T40280 and insert in the trim panel for installation.