Height, Adjusting Using Adjusting Buffer

• Adjustment dimensions. Refer to ADJUSTMENT DIMENSIONS .

Procedure 

-- Install the adjusting screw -2- with the cap -1- all the way into the adjusting buffer -3- before adjusting the rear lid.

Fig 1: Adjusting Screw, Adjusting Buffer And Cap

Courtesy of AUDI OF AMERICA, LLC

-- Remove the adjusting screw -2- just enough until the cap -1- makes contact with the stop on the body side with light pretension when the rear lid is closed.

-- Check if the lid is without play and in a flush position by pressing or pulling at the side edges of the rear lid.

-- Repeat the adjustment if necessary.