Lock Carrier, Removing And Installing: Removing
-- Remove the left and right headlamp. Refer to HEADLAMP, REMOVING AND INSTALLING .
-- Remove the High Tone Horn - H2- and Low Tone Horn - H7-. Refer to HIGH TONE HORN -H2- /LOW TONE HORN -H7-, REMOVING AND INSTALLING .
-- Remove the impact member. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
-- Release the retainers with the : T10118 -arrows-.
-- Lift the upper air duct -1- slightly and remove the side air duct -2-.
-- Release and disconnect the connector -2- for the High Pressure Sensor -G65-.
Risk of destroying the refrigerant lines by tearing the inner film.
- Never bend refrigerant lines with a radius less than 100 mm.
-- Release the catches -arrows- disengage the condenser -1- from the radiator and tie up to the side.
-- Remove the bolt -arrow- on the left and right.
There is a risk of hand injury if the radiator fan turns on by itself.
- Do not reach into the radiator fan when disconnecting the connector.
-- Release and disconnect the connectors -1 and 2- for the radiator fan.
-- Place the container of the : VAS5014 or the : VAS6208 underneath.
-- Lift the clamp -arrow-.
-- Remove the coolant hose from the radiator on the right bottom side and let the coolant drain.
-- Equipped on some models: lift the clamp -arrow-.
-- Equipped on some models: remove the coolant hose from the radiator on the left bottom side and let the coolant drain.
-- Lift the clamps -1 and 2-, remove and free up the coolant connection from the radiator.
-- Remove the charge air cooler. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
-- Seal the open lines and connections with clean plugs from the : VAS6122 .
-- Free up the hoses and wires.
-- Disconnect the latch cable at the coupling and free it up on the lock carrier. Refer to OVERVIEW - RELEASE CABLE .
-- Have a second technician hold the lock carrier -1- and remove the bolts -2 and 3-.
-- Remove the lock carrier with a second technician.
-- The following components must also be removed if the lock carrier is being replaced:
- Lower and upper front air duct pipe on the lock carrier. Refer to OVERVIEW - CHARGE AIR SYSTEM .
- Radiator. Refer to RADIATOR, REMOVING AND INSTALLING .
- If equipped, coolant pipe on lower lock carrier. Refer to OVERVIEW - RADIATOR/RADIATOR FAN .
- Lower air duct. Refer to OVERVIEW - RADIATOR/RADIATOR FAN .
- Latch. Refer to LATCH, REMOVING AND INSTALLING .
- Bracket for the lower longitudinal member. Refer to LOWER LONGITUDINAL MEMBER BRACKET, REMOVING AND INSTALLING .