Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING, VEHICLES WITH 48V SYSTEM: Removing
-- Disconnect the ground cable to the Battery -A- when the ignition is switched off. Refer to 48V SYSTEM, DE-ENERGIZING .
- On vehicles with 48 volt system (PR number VH2/VH3) must be de-energized before the 48 V system. Refer to 48V SYSTEM, DE-ENERGIZING .
-- Remove the Terminal 30a Wire Junction -TV3- and move it to the side with the wires still connected. Refer to Terminal 30a Wire Junction -TV3-, REMOVING AND INSTALLING .
-- Remove the terminal 40 wire junction and move it to the side with the wires still connected. Refer to Terminal 40 Wire Junction -TV66-, REMOVING AND INSTALLING .
-- Disconnect the connector -5-.
-- Remove the nuts -2 and 3- and free up the wires -1 and 6-.
-- Remove the nuts -arrows-.
-- Remove the wire junction -4- from the threaded pins.