Terminal 40 Wire Junction 2 -TV67-, REMOVING AND INSTALLING: Removing

-- De-energize the 48V system. Refer to 48V SYSTEM, DE-ENERGIZING .

-- Disconnect the ground cable to the Battery -A- when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the partition cover. Refer to COMPONENT LOCATION OVERVIEW - VEHICLE INTERIOR TRIM PANELS .

-- Release the retainer in direction of -arrow B- and open the cover -1- in direction of -arrow A-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clips -3, 4, and 5-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -6- and free up the wire.

-- Remove the nuts -2, 7, and 9- and free up the wires.

-- Remove the bolt -8-.

-- Remove the Terminal 40 Wire Junction 2 -TV67- -1-.