Oil Spray Jets, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi S7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the oil tray. Refer to OIL TRAY, REMOVING AND INSTALLING .
CAUTION:
Risk of damaging the engine by the timing mechanism skipping.
- Only let the engine turn in the direction of engine rotation.
-- Turn the crankshaft using the Wrench - 21mm: T40263 and Adapter: T40314 -arrow- until the corresponding oil spray jet is accessible.
-- Mark the installation position and the connecting rod bearing cap allocation to the cylinder and connecting rod for installing again later. Refer to Figure.
-- Remove the corresponding bolts -arrows- and remove the connecting rod bearing cap.
-- Remove the banjo bolt -2- and the oil spray jet -1-.
-- Repeat the procedure if necessary on each oil spray jet.