Engine, Removing From Scissor Lift Table

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Lifting Tackle: 3033

Fig 1: Lifting Tackle (3033)
Courtesy of AUDI OF AMERICA, LLC
Shop Crane: VAS6100

Fig 2: Identifying Shop Crane
Courtesy of AUDI OF AMERICA, LLC
Lift Arm Extension: VAS6101

Fig 3: Identifying Lift Arm Ext./Workshop Hoist VAS 6101
Courtesy of AUDI OF AMERICA, LLC

Procedure

NOTE:

The engine may only be transported in the manner described and without the transmission.

Engine/transmission assembly removed and separated on the Scissor Lift Table: VAS6131B . Refer to ENGINE AND TRANSMISSION, SEPARATING .

-- Attach the Lift Arm Extension: VAS6101 to the Shop Crane: VAS6100 .

Courtesy of AUDI OF AMERICA, LLC

-- Engage the Lifting Tackle: 3033 on the engine lifting eyes and on the workshop crane as shown.

-- Remove the left and right bolts -2-. (Shown on the installed engine.)

Courtesy of AUDI OF AMERICA, LLC

-- Pry up the engine with the workshop crane.