Electro-Hydraulic Engine Mount, Calibrating
WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Calibration must only be performed on electrohydraulic engine mounts with sensor and actuator for assembly mounts.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
Procedure
-- Connect the Vehicle Diagnostic Tester.
-- Select the Diagnostic mode and start the diagnosis.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Drivetrain
- Engine - auxiliary and subsystem
- 01 - OBD-capable systems
- BA - Assembly Mount Control Module
- BA - Assembly Mounts Control Module, Functions
- BA - Performing Basic Setting
- Preform the test