Overview - Coolant Pipes
WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- The arrows on the coolant pipes and ends of coolant hoses must align.
- Left Front Coolant Pipe
- Removing and Installing. Refer to LEFT FRONT COOLANT PIPE, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replace after removing
- Bolt
- 9 Nm
- Front Coolant Pipe
- Replace after removing
- Removing and Installing. Refer to FRONT COOLANT PIPE, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replace after removing
- O-Ring
- Replace after removing
- Bolt
- 9 Nm
- Connection
- O-Ring
- Replace after removing
- Bolt
- 9 Nm
- Large Right Rear Coolant Pipe
- Removing and Installing. Refer to LARGE RIGHT REAR COOLANT PIPE, REMOVING AND INSTALLING .
- Clamp
- Bolt
- 9 Nm
- Clamp
- Bolt
- 9 Nm
- O-Ring
- Replace after removing
- Clamp
- Bolt
- 9 Nm
- Small Right Rear Coolant Pipe
- Removing and Installing. Refer to SMALL RIGHT REAR COOLANT PIPE, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Rear Left Coolant Pipe
- Removing and Installing. Refer to LEFT REAR COOLANT PIPE, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Bolt
- 9 Nm
- O-Ring
- Replace after removing
- O-Ring
- Replace after removing
- Bolt
- 9 Nm
- Connection
- Seal
- Replace after removing
- Bolt
- 9 Nm
Right Coolant Pipe - Tightening Specification
-- Tighten the bolt -2- to 9 Nm.
Coolant Pipes on Longitudinal Member - Tightening Specifications
-- Tighten the nuts -3- to 5 Nm.
NOTE:
Ignore -1 and 2-.
Coolant Pipe on Right Lower Longitudinal Member - Tightening Specifications
-- Tighten the nuts -arrows- to 5 Nm.
NOTE:
Ignore -1 through 6-.
Coolant Pipe on Left Upper Longitudinal Member - Tightening Specifications
-- Tighten the nuts -2- to 5 Nm.
Coolant Pipe on Left Lower Longitudinal Member - Tightening Specifications
-- Tighten the bolts and nuts -arrows- to 5 Nm.