HOUSING FOR Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Removing

-- Remove the radiator at the same time the fan shroud stays in the radiator. Refer to RADIATOR, REMOVING AND INSTALLING .

-- Loosen the hose clamp -6-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Remove the coolant hose -8- from the housing for the Map Controlled Engine Cooling Thermostat -F265-.

-- Move the coolant pipe -4- to the right side.

-- Lift the clamp -2- and loosen the hose clamp -1-, and remove the coolant hose.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1-.

Fig 1: Component Location: on the Front of the Engine, Cylinder Bank 1 (Right)

Courtesy of AUDI OF AMERICA, LLC

-- Push the wiring duct -2- upward.

-- Remove the bolts -arrows-.

Fig 2: Component Location: on the Front of the Engine, Cylinder Bank 2 (Left)

Courtesy of AUDI OF AMERICA, LLC

-- Unclip and free up the vacuum line -2- on the wiring duct -3-.

-- Push the wiring duct -3- upward.

-- Disconnect the connectors and free up the wires.

Courtesy of AUDI OF AMERICA, LLC

3 -  For the Map Controlled Engine Cooling Thermostat -F265-

4 -  For the Oil Pressure Sensor -G10-

-- Remove the bolt -2- and free up the vacuum line -1-.

All additional procedures are described. Refer to HOUSING FOR Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING Coolant Regulation Housing, Removing and Installing.