Brake Rotor, Removing And Installing, Steel Brakes: Installing
WARNING: This page is about a different car, the 2022 Audi Q7, 2021 Audi Q7, and 2020 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Clean bolts before reusing.
- Replace damaged bolts.
- Always replace self-locking bolts.
-- Check the brake rotors for wear and damage before reusing them:
- Brake rotor wear limit. Refer to TECHNICAL DATA .
WARNING:
Risk of accident due to insufficient braking effect.
If a ceramic brake rotor is at the end of its wear specification, check the other brake rotors for damage and wear.
-- Thoroughly clean the brake rotor and hub contact surfaces and clear them of corrosion.
-- Do not tilt the brake rotor when mounting it on the wheel hub.
-- Tighten the bolt -arrow-.
-- Install the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING .
WARNING:
Risk of accident!
- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
- Make sure the brakes are working correctly before driving the vehicle for the first time.