Brake Caliper, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi Q7, 2021 Audi Q7, and 2020 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Clean bolts before reusing.
- Replace damaged bolts.
- Always replace self-locking bolts.
WARNING:
Health Risk.
- Do not blow out brake system with compressed air.
NOTE:
Use only mineral spirits to clean the brake caliper.
-- Carefully slide the brake caliper with the brake carrier and the brake pads installed over the brake rotor.
-- Tighten the bolts -arrows- on the brake carrier.
NOTE:
Make sure that the wire and brake hose are routed correctly.
Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.
-- Install the brake pad wear indicator wire. Refer to BRAKE PAD WEAR INDICATOR WIRE, REMOVING AND INSTALLING .
-- Install the rear wheel. Refer to Wheels and Tires .
-- Drive the parking brake motor out. Refer to Vehicle Diagnostic Tester by following the instructions in the display.
WARNING:
Risk of accident!
- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly set in their respective position.
- Make sure the brakes are working correctly before driving the vehicle for the first time.