Rear Seat Backrest Contact Switch, Removing And Installing, Seat High, Outer Second Row: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the seat rail trim panel on the side sill side. Refer to SEAT RAIL TRIM PANEL ON SIDE SILL SIDE, REMOVING AND INSTALLING, SEAT HIGH, OUTER SECOND ROW .

-- Remove the bolts -5- and fold the trim panel bracket -4- to the side.

-- Loosen the clip -3-.

-- Remove the bolt -2-.

-- Remove the Left Rear Seat Backrest Contact Switch -F315- or Right Rear Seat Backrest Contact Switch -F316- -1- and release and disconnect the connector.

Installing and Adjusting

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

Open the lock for the seat folding release -arrow-.

-- Position the Left Rear Seat Backrest Contact Switch -F315- or Right Rear Seat Backrest Contact Switch -F316- -3- so that the rocker switch is slightly vertical near the release lever -1-.

-- Tighten the bolt -2-.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is risk of fingers being pinched and injury when closing the seat folding lock.

Close the seat folding lock with a screwdriver, for example.

-- Close the seat folding lock on both sides using a screwdriver, for example -arrow-.

-- The release lever must release the rocker switch.

-- If necessary, loosen the bolt -2- and slide the switch -3- correspondingly.