Overview - Rear Seat Backrest, Second Row Backrest Without Center Armrest
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Seat/Backrest Frame
- Cannot be separated
- Spiral Spring
- Release Lever
- For backrest
- Lock Washer
- Replace after removing.
- Pull Loop
- For the backrest release
- Removing and Installing. Refer to TUNNEL-SIDE SEAT SIDE TRIM, REMOVING AND INSTALLING, OUTER SECOND ROW SEAT .
- Trim for Net Partition
- Equipped on some models
- Press on until it engages audibly.
- Removing and Installing. Refer to SCREEN SEPARATOR TRIM, REMOVING AND INSTALLING, OUTER SECOND ROW SEAT .
- Cover
- For the upper child seat anchor
- Press into the seat frame until it engages audibly.
- Removing and Installing. Refer to UPPER CHILD SEAT ANCHOR COVER, REMOVING AND INSTALLING, SECOND AND THIRD ROW .
- Trim
- for the seat folding release handle
- Equipped on some models
- Press on until it engages audibly.
- Removing and Installing. Refer to SEAT FOLDING RELEASE HANDLE, REMOVING AND INSTALLING, SEAT HIGH, OUTER SECOND ROW .
- Handle
- for seat folding release
- Equipped on some models
- Lock the inner and outer shell for the release handle carefully together
- Removing and Installing. Refer to SEAT FOLDING RELEASE HANDLE, REMOVING AND INSTALLING, SEAT HIGH, OUTER SECOND ROW .
- Shaft
- for rear seat backrest locking mechanism
- Removing and Installing. Refer to REAR SEAT BACKREST LOCKING MECHANISM, REMOVING AND INSTALLING, OUTER SECOND ROW SEAT .